Main /
General DM542T Digital Stepper Drive Notes
Switch Settings
DIP Switch Settings
The DIP switch settings used for NEMA 23 motors are
|
Purpose |
Switch |
Motor |
Configuration Set | ||||||||||||||||
|
NEMA 17 |
NEMA 23 | ||||||||||||||||||
|
Current |
SW 1 |
OFF |
ON |
| |||||||||||||||
|
SW 2 |
ON |
ON | |||||||||||||||||
|
SW 3 |
ON |
OFF | |||||||||||||||||
|
Idle Current |
SW 4 |
OFF |
OFF |
OFF = 50% current @ standstill | |||||||||||||||
|
Microstepping |
SW 5 |
OFF |
OFF |
1.8° step angle ⇒ 200 steps/rev | |||||||||||||||
|
SW 6 |
ON |
ON | |||||||||||||||||
|
SW 7 |
OFF |
OFF | |||||||||||||||||
|
SW 8 |
ON |
ON | |||||||||||||||||
The current could be set higher with this driver; however, the selected NEMA 17 & 23 stepper motors do not need that, so it is set thusly.
Control Signal Voltage Switch Setting
The Control Signal Voltage Switch (5V | 24V) is set to 5V.
|
eMail comments to |